Ricoh SP 200S Operating Instructions Manual page 104

1. Guide to the Machine
5. Make sure [Use IPv6] is set to [On].
After a setting is changed, the machine automatically restarts.
Assigning the machine's IPv6 address manually
• The IPv6 address assigned to the machine must not be used by any other device on the same
network.
• Make sure [DHCPv6] is set to [Disable] in [IPv6] in Web Image Monitor. For information about
how to launch Web Image Monitor, see page 123 "Using Web Image Monitor".
1. Press the [
2. Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Machine IPv6 Address], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Use IPv6], and then press the [OK] key.
5. Make sure [Use IPv6] is set to [On].
If this setting is changed, the machine will reboot automatically before the procedure is complete.
When this happens, wait for the reboot to finish, repeat Steps 1 to 3, and then proceed to the next
step.
6. Press the [ ] or [ ] key to select [Manual Config. Add.], and then press the [OK] key.
7. Press the [ ] or [ ] key to select [IP Address], and then press the [OK] key.
8. Enter the machine's IPv6 address using the number keys.
9. Enter the values in all fields, and then press the [OK] key.
If this setting is changed, the machine will reboot automatically before the procedure is complete.
When this happens, wait for the reboot to finish and repeat the procedure except Steps 4, 5, 7, 8,
and 9.
10. Press the [ ] or [ ] key to select [Prefix Length], and then press the [OK] key.
18
] key.
CTT006