Ricoh SP 200S Operating Instructions Manual page 217

Ethernet
Item
Host Name Enter the host name you want to set for the network interface board, using up to
63 characters. The default is RNP, followed by the MAC address of the active
interface board. If you change the name to other than the default, the new name
cannot begin with "RNP" or "rnp".
Domain Name Enter the name of the domain to which the device belongs, using up to 63
alphanumeric characters.
Link-local Address Displays the link-local address of the network interface board.
The link-local address applies only within the local network (local segment) and
begins with "fe80::", followed by an identifier generated from the MAC address
of the active interface board.
Stateless Address Displays the stateless address for router.
Stateful Address Displays the stateful address.
Manual In the left box, enter the IPv6 address assigned for the network interface board.
Configuration
In the right box, enter the prefix length of the IPv6 address, using a value
Address
between 0 and 128. The default is 64.
• The following addresses cannot be set:
DHCPv6 Select [Enable] to use the DHCPv6 server to automatically configure the
network settings. Select [Disable] to manually configure the network settings.
DDNS Select whether DDNS (Dynamic DNS) name resolution for the network interface
board is active or inactive.
When active, the DNS database is immediately updated.
Link-local addresses, multicast addresses, loopback addresses, IPv4-
compatible addresses, and IPv4-mapped addresses
Using Web Image Monitor
Description
131