Ricoh SP 200S Operating Instructions Manual page 350

Changing the IP Address Settings Using the Web Image Monitor
Starting Web Image Monitor
1. Launch the Web browser.
2. In the address bar, enter "http://(machine's IP address)/".
• IPv4 Address
Enter the IP address shown on the network setting list.
Use a computer using the IP address shown on the network setting list with its variable
part modified.
• IPv6 Address
Enter the IP address shown in "Link-local Address" in the network setting list. Enclose the
IP address in square brackets, thus: "http:/[fe80:226:73ff:fe47:62e]/".
3. Click [Log in].
4. Enter the administrator password, and then click [Log in].
If you are logging in for the first time, enter "admin133" as the password.
Configuring the Machine Settings to Obtain an IPv4 Address Automatically
Check that [DHCP] is set to [Enable] in [IPv4] in Web Image Monitor. If [DHCP] is set to [Enable],
the machine can automatically obtain the IP address.
CTT163
15