Endress+Hauser Proline Prosonic Flow 93 Function Manual page 146

11 Block SUPERVISION
146
VALUE SIMULATION
!
MEASURAND
This function is available in groups SYSTEM+SYSTEM CH2.
(8044)
!
The function is not visible unless the function SIMULATION MEASURAND (8043) is
active.
Use this function to specify a selectable value (e.g. 12 m
associated functions in the device itself and downstream signal loops.
User input:
5-digit floating-point number, [unit]
Factory setting:
0 [unit]
"
• The setting is not saved if the power supply fails.
• The appropriate unit is taken from the function group SYSTEM UNITS (ACA),
SYSTEM RESET Use this function to perform a reset of the measuring system.
(8046)
Options:
NO
RESTART SYSTEM (restart without interrupting power supply)
Factory setting:
NO
OPERATION HOURS The hours of operation of the device appear on the display.
(8048)
Display:
Depends on the number of hours of operation elapsed:
Hours of operation < 10 hours
Hours of operation 10...10,000 hours
Hours of operation > 10,000 hours
Functional description
➞
SUPERVISION [CH2] SYSTEM
Note!
Note!
Caution!
(see Page 15).
→
display format = 00:00:00 (hr:min:sec)
→
Device functions Proline Prosonic Flow 93
➞
OPERATION
3
/s). This is used to test the
→
display format = 0000:00 (hr:min)
display format = 000000 (hr)
Endress+Hauser