Mircom TX3 SERIES Programming Manual page 40

Table 3 describes the information you will need to auto program the panel.
Table 3: Auto Programming Information
Programming Menu
Number of Records
[____]
Enter Resident
Name
[____________]
Start Dialcode
[____]
Start Keyless Code
[____]
Line Number to use
[__]
Start Relay Number
[____]
To use the auto program
1.
2.
Note:
40 Telephone Access System Programming Manual
LT-979 Copyright 2016
NSL ADC
System System
Enter the total number of residents to auto
program (4 digits). Scroll up or down to the
YES YES
desired number, then press enter (telephone
key). Must be 10 or more.
Enter the resident's name (maximum 10
YES YES
characters).
Enter the start number of Dial Codes to auto
program. The starting code will be entered in
YES YES
increments of 1, up to the number of residents
entered.
Enter the start number of the keyless codes, if
used. The starting code will be entered in
YES YES increments of 1, up to the number of residents
entered. These codes are used by the visitors to
enter without calling the resident.
Enter the Line number you wish for this lobby
unit to connect to. This Line numbers will be
YES YES
used by the number of residents entered. Lines
1 to 5 are available.
Enter the start relay number to auto program.
The starting relay number will be entered in
YES N/A increments of 1, up to the number of residents
entered. Please note that the relay number
starts at 1 for the first relay.
Scroll the arrow to "Auto Program" database menu and press the enter
(telephone) key. The display will now show the following message:
Number of Records
< 010>
Use the up arrow to move from number of residents in increments of 5 to
the desired number. The maximum depends on the TX3 Model (it can be
200, 1000 or 2000).
Only 200 names can be added at a time.
Explanation/Description
Configuration
Version 2.4