Transmission - NEC NEFAX 671 Service Manual

Code
005B Did not detect phase E signal after primary channel within 6 seconds.
005C Detect busy tone within control channel after phase C.
005D Remote-side disconnect at phase C (V.34).
005E Did not detect control channel signal after received RCP frame within 6 seconds.
005F Did not detect silence after sending JM signal for polling TX function.
0060 There are no bulletin files to be polled in V.34.
0061 Machine can not detect V.21 or V.8 signal within 35 seconds.
Modem disconnect in phase D after our side sending out flag sequence in control
0062
channel.
Did not receive any flag sequence in control channel within 6 seconds in phase
0063
D.
Did not detect any control channel signal in phase D within 60 seconds even
0064
though energy still on the line.
Did not detect any control channel signal within 60 seconds after detect silence in
0065
phase D.
0066 Did not receive T.30 signal or carrier signal after sending CFR in V.34.
0070 User presses stop key during receiving.
0071 Memory full during receiving.
(2)

Transmission

Code
0080 Did not detect any G3 signal within 35 sec. specified by ITU-T in phase B.
0081 Received DTC signal in transmission phase.
0082 Transmitting unit receives a signal other than DIS or DTC. and DCN in phase B.
0083 Detected FSK signal, but did not receive any signal within 35 seconds.
0084 Detect DCN signal in phase B.
Transmitting unit sending DCS 3 times consecutively, but each time receiver
0085
responds with DIS/DTC.
Detected response signal other than DTC, DIS, FTT, DCN or CFR after sending
0086
DCS.
0087 Training attempt has failed because speed unit cannot adjust to low lower speed.
0088 Received DCN signal after sending out DCS signal.
0089 Remote side no mailbox function or not compatible.
008A Remote side not enough memory for relay initiate.
008B Receiver's protocol of DIS is received, but it is not compatible with our machine.
008C Remote side not enough memory for relay initiate.
Receiver's protocol of DIS is received, but remote side can't receive document
008D
temporary, may be run out of paper or other reason.
Remote side CSI number not defined in machine one touch or speed dial direc-
008E
tory.
Possible Causes of Error.
Possible Causes of Error.
T-41