C0510: Fuser Temperature Low - NEC NEFAX 671 Service Manual

(4)

C0510: Fuser temperature low

<Detection Timing>
• The temperature detected by the Thermistor remains lower than the set temperature
continuously for a predetermined period of time while the fusing temperature control is
being provided. (The set temperatures are as follows: 140 °C during a print mode at 600
dpi; 70 °C during the standby mode.)
<Troubleshooting Procedures>
Fusing Unit
Thermistor (TH1)
Fusing Roller Heater Lamp (H1)
Step Action
1 Replace Thermistor (TH1).
2 Replace Fusing Unit.
3 Replace Controller/Mechanical
Control Board (PWB-P).
4 Replace Power Unit (PU1).
Description
Relevant Electric Parts
Controller/Mechanical Control Board (PWB-P)
Thermostat (TS1)
Power Unit (PU1)
Ref. Page
Control Signal
☞ D-28
☞ E-7
☞ D-12
☞ D-15
T-19
WIRING DIAGRAM
Location
(Electric Parts)
– –
– –
– –
– –