Panasonic VL-V900 Installation And Operating Instructions Manual page 41

Connection check
Allows you to confirm the control box's connection to the main monitors and lift controllers.
5.2.4 Using the setup tool to edit data
1
Start the setup tool.
2
In the [Prepare the data] section, click [Check Files].
R The paths of each configuration file are displayed in the [Load and edit the data] section.
3
In the [Load and edit the data] section, click [Load / Edit ...] next to a configuration file that you want to edit.
R The files's details are displayed.
4
For [Room settings] for lobby stations 1–3
a. Click [Edit ...] to open the configuration file.
R Use a third-party text editor or spreadsheet program to open the configuration file.
b. Change the values in the appropriate columns, and then save the file.
c. In the setup tool, click [Reload].
R The content of the configuration is reloaded and displayed.
d. Click [Close].
For all other settings
a. Select the desired setting.
b. Enter the desired value in the [Edit Data] section.
R Acceptable values are displayed in a pop-up when you mouse-over the text field.
c. Click [Apply / Save] to save the settings to the configuration file.
d. Click [Close].
5
Repeat from step 3 for each configuration file that you want to edit.
R Files that are ready to be uploaded are indicated by [OK] displayed in the right side of the [Load and edit the
data] section.
6
In the [Upload the data to device] section, select the devices that you want to upload the data to and then click
[Upload].
Note:
R See 5.2.10 List of PC programming parameters (Page 42) for information about each parameter.
5.2.5 Downloading and backing up data
You can download the data that is saved in the system's devices, and back them up on your computer.
1
Start the setup tool.
2
In the [Prepare the data] section, turn on the checkboxes for the desired devices listed under [Download the
data from].
3
Click [Download].
R The data from the selected devices is downloaded to your computer and overwrites the configuration files
saved on your computer.
R Refer to the [Select folder] section and note the location of the configuration files.
4
Backup the configuration files as needed.
5.2.6 Editing configuration files directly
You can edit large amounts of data by editing configuration files directly.
1
Start the setup tool.
2
Refer to the [Select folder] section and note the location of the existing configuration files.
R If you want to create new configuration files in a different folder, create the folder on your computer, select the
folder in the [Select folder] section, and then click [Create Files] in the [Prepare the data] section.
3
Using your computer's file explorer, open the folder containing the existing configuration files.
5. Programming
41