Panasonic VL-V900 Installation And Operating Instructions Manual page 46

5. Programming
2
Press M#N ® enter the access code ® M
R The default access code is "123456". If necessary, you can change the access code (Changing the access
code (Page 46)).
3
Set each parameter.
R You can browse parameters by pressing M N and M N, and select a parameter by pressing M
R You can return to the previous screen by pressing M
R See 5.3.1 List of lobby station programming parameters (Page 46) for information about each parameter.
4
Press M N when finished.
R The lobby station exits programming mode and the standby screen is displayed.
Entering numbers and characters
You can use the keypad to enter numbers and characters.
R Press a key repeatedly to scroll through the characters assigned to that key.
R Follow the hints displayed on the bottom of the display.
– To erase all numbers or characters, press MHN.
– To advance the cursor, press M#N.
– To cancel, press M
– To confirm or save the entered numbers or characters, press M
Changing the access code
The access code is required to use the lobby station programming.
1. Press M#N ® enter the access code ® M
R The default access code is "123456".
2. Select "SET ACCESS CODE" ® M
3. Enter the desired 6-digit code ® M
4. Press M N.
5.3.1 List of lobby station programming parameters
The following parameters are available when using lobby station programming.
Note:
R You can also use PC programming to configure these settings for each main monitor. Parameter names are slightly
different when using PC programming.
Parameter
SET ROOM NO.
DELETE ROOM NO.
SET DOOR KEY
DOOR KEY OPEN TIME
DOOR KEY OUT SIGNAL
46
N.
N.
N.
N.
N.
Description and available settings
Determines the room number and resident name.
(1–99999, 20 characters max., lowercase letters not
available)
R See Entering numbers and characters (Page 46) for
more information.
Deletes the room number and resident name.
(1–99999)
Determines the amount of time the door stays open. If
set to 0 SEC, the door cannot be opened.
(01–20 SEC, or 00 to disable)
Determines whether the signal sent to the electric lock
is a closed signal (i.e., the signal is normally open) or
an open signal (i.e., the signal is normally closed).
[00]: CLOSE
[01]: OPEN
N.
N.
N.
Default
—
—
05
(5 SEC)
00
(CLOSE)