Main Monitor Programming - Panasonic VL-V900 Installation And Operating Instructions Manual

5. Programming
5
Enter a feature number to specify the terminal's operation mode.
Feature number
00# (default)
01#
6
Hang up.
Note:
R A compatible main monitor, such as the VL-MVN511, is required to make emergency calls to the emergency
terminal.
Deleting a terminal assignment
Use this procedure to stop using a terminal with the system.
1. Dial the extension number assigned to the control box.
2. Enter a feature number to specify which terminal will be deleted.
Feature number
##*0# #
##*1# #
##*2# #
##*3# #
##*4# #
3. Hang up.

5.5 Main monitor programming

Use this procedures in this section to configure the following settings. Perform this procedure for each main monitor.
– Set the main monitor to apartment mode
– Set the room number
– Set the floor number
– Set lift permissions for visitors
Note:
R You can also use PC programming to configure these settings for each main monitor.
R Operations vary depending on the model number of the main monitor.
When programming the VL-MVN511
1. Press and hold the second soft key button from the left, M
R Continue to hold the buttons and perform the next step.
2. Press and hold the MRESETN button for about 3 seconds, then release the MRESETN button only.
R The main monitor starts up and enters programming mode.
50
Description
For the emergency terminal
Selects EMERGENCY TALK mode. During an
emergency call, the main monitor can talk to the
emergency terminal (up to 10 minutes).
For terminals 1–4
Selects NORMAL TERMINAL mode. The terminal
cannot be used as a reception terminal.
For the emergency terminal
Selects EMERGENCY NOTICE mode. During an
emergency call, the emergency terminal receives a
repeating emergency announcement.
For terminals 1–4
Selects RECEPTION TERMINAL mode. The terminal
can be used as a reception terminal.
Description
Emergency terminal
Terminal 1
Terminal 2
Terminal 3
Terminal 4
N, and M N at the same time (3 buttons total).