Other Information - Panasonic VL-V900 Installation And Operating Instructions Manual

– System event information
– Doorphone camera images
2. Information stored in the control box and lobby station
– Resident names and room numbers
– System settings
3. Information stored on the computer that is used by
the setup tool
– Resident names and room numbers
– System settings
Data security guidelines
R Do not allow unauthorised access to the control
box and its SD memory card.
The control box should be installed in a restricted
access location, where only authorised personnel
may gain access through the use of a special tool,
lock and key, or other means of security.
Note that the SD memory card, which contains a log
of all system event information, can be removed by
anyone with access to the control box.
R Observe proper management of passwords,
access codes, etc.
Access codes can be used to program the system,
open doors, etc. Select codes that are difficult to
guess, change them regularly, and keep them secret.
R Protect user information when sending the
control box or lobby station to be repaired, or
when handing them over to a third party.
Remove the SD memory card from the control box.
Keep it in a secure place until lit is needed again.
Use the setup tool to download all data stored in the
control box and lobby station. (This will back up all
data and save it on your computer.) Then use the
setup tool to upload blank configuration files (i.e., files
that contain no user information) to the control box or
lobby station.
R Protect user information stored on the computer
used to configure the system.
When user information is sent stored on a computer,
the confidentiality of that information becomes the
responsibility of the customer. Before disposing of
the computer, ensure that data cannot be retrieved
from it by formatting the hard disk and/or rendering it
physically unusable.
R Protect user information when disposing of the
control box or lobby station.
Remove the SD memory card from the control box.
Render it physically unusable and dispose of it.
Use the setup tool to upload blank configuration files
(i.e., files that contain no user information) to the
control box or lobby station.

2.4 Other information

R If you stop using the product, remove it from the walls
to prevent it from falling off.
R When power fails, this product cannot be used.
R Panasonic may not be liable for damages due to
external factors such as power failures.
R The recorded images may be lost when:
– Mishandled
– Electric shock or radio wave interference occurs.
– The power is turned off during use.
R To the maximum extent permitted by law, Panasonic
assumes no responsibility for injuries or property
damage resulting from failures arising out of improper
installation or operation inconsistent with this
document.
Disposal of Old Equipment (Only for European Union
and countries with recycling systems)
This symbol (A) on the products, packaging, and/or
accompanying documents means that used electrical
and electronic products must not be mixed with general
household waste.
For proper treatment, recovery and recycling of old
products, please take them to applicable collection
points in accordance with your national legislation.
By disposing of them correctly, you will help to save
valuable resources and prevent any potential negative
effects on human health and the environment. For more
information about collection and recycling, please
contact your local municipality.
Penalties may be applicable for incorrect disposal of this
waste, in accordance with national legislation.
Information on Disposal in other Countries outside
the European Union
This above symbol (A) is only valid in the European
Union. If you wish to discard this product, please contact
your local authorities or dealer and ask for the correct
method of disposal.
2. Important Information
1
7