Panasonic VL-V900 Installation And Operating Instructions Manual page 51

3. When the display lights up, release all the buttons.
4. Use the navigator key to select "Apartment mode" ®
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing M
5. Enter the room number.
a. Use the navigator key to select the desired number.
b. Use the navigator key to accept the entered number and advance the cursor.
c. Press when finished.
6. Enter the floor number.
a. Use the navigator key to select the desired number.
b. Press when finished.
7. Set the visitor lift permissions for "Lift 1".
a. Use the navigator key to allow or prohibit lift usage for visitors to each lobby.
b. Use the navigator key to select the next lobby station.
c. Press when finished.
R Repeat the above procedure for "Lift 2" and "Lift 3".
8. Confirm the displayed settings.
R Press to go back and enter the desired settings again.
9. Press to check for a duplicate room number.
R If a duplicate room number is found, press
to cancel saving the settings.
If no duplicate is found, the settings are saved in the control box.
Note:
R If you press
the settings in the control box, press
When programming the VL-MW251
1. Press and hold MOFFN, MTALKN, and MMENUN at the same time (3 buttons total).
R Continue to hold the buttons and perform the next step.
2. Press and hold the MRESETN button for about 3 seconds, then release the MRESETN button only.
R The main monitor starts up and enters programming mode.
3. When the display lights up, release all the buttons.
4. Press the or
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing MOFFN.
5. Enter the room number.
a. Press or
b. Press to accept the entered number and advance the cursor.
c. Press when finished.
6. Enter the floor number.
a. Press or
b. Press when finished.
7. Set the visitor lift permissions for "LIFT 1".
a. Press or
b. Press to select the next lobby station.
c. Press when finished.
R Repeat the above procedure for "LIFT 2" and "LIFT 3".
8. Confirm the displayed settings.
R Press to go back and enter the desired settings again.
, the settings will be saved in the main monitor only, and the main monitor will restart. To save
soft keys to select "APARTMENT MODE" ®
to select the desired number.
to select the desired number.
to allow or prohibit lift usage for visitors to each lobby.
.
to overwrite the existing room number settings, or
.
5. Programming
N.
.
51