Panasonic VL-V900 Installation And Operating Instructions Manual page 20

4. Installation
3. Connect the AC cable to the AC IN terminal on the top of the power unit, and the DC cable to the DC OUT terminal
on the bottom of the power supply unit, and then securely fasten the screws (C).
AC IN terminal
*1 View with the cable covers removed.
R Recommended torque:
– AC terminal: 0.4 N·m {4.1 kgf·cm}
– DC terminal: 0.45 N·m {4.6 kgf·cm}
CAUTION
R Insert the AC and DC cables firmly all the way into the terminals. If the cables are not inserted all the way, heat
may be generated.
4. Use the cable binders (accessory) to secure the AC and DC cables (double-coated area) to the power supply unit.
5. Make sure to replace the cable covers (B) and then securely fasten the screws (A).
Mounting on a DIN rail
Follow the procedure in the order described below so that hook (A) is positioned at the bottom.
1. Hang the top hooks (B) on the DIN rail (C).
2. Pull and hold the lever down (D).
3. Secure the bottom hook (A) to the DIN rail (E).
20
C
*1
Top view
AC cable
binder hole
B
A
D
*1
Front view
DC cable
binder hole
C
E
*1
Bottom view
DC OUT terminal