Panasonic VL-V900 Installation And Operating Instructions Manual page 52

5. Programming
9. Press to check for a duplicate room number.
R If a duplicate room number is found, press
existing room number settings.
If no duplicate is found, the settings are saved in the control box.
Note:
R If you press
the settings in the control box, press
When programming the VL-MV26
1. Press and hold M
R Continue to hold the buttons and perform the next step.
2. Press and hold the MRESETN button for about 3 seconds, then release the MRESETN button only.
R The main monitor starts up and enters programming mode.
3. When the display lights up, release all the buttons.
4. Enter the room number.
a. Press or
b. Press to accept the entered number and advance the cursor.
c. Press when finished.
5. Enter the floor number.
a. Press or
b. Press when finished.
6. Set the visitor lift permissions for "LIFT 1".
a. Press or
b. Press to select the next lobby station.
c. Press when finished.
R Repeat the above procedure for "LIFT 2" and "LIFT 3".
7. Confirm the displayed settings.
R Press to go back and enter the desired settings again.
8. Press to check for a duplicate room number.
R If a duplicate room number is found, press
existing room number settings.
If no duplicate is found, the settings are saved in the control box.
Note:
R If you press
the settings in the control box, press
When programming the VL-MWD272/VL-MWD273/VL-MV71/VL-MV72
1. Press and hold M
R Continue to hold the buttons and perform the next step.
2. Press and hold the MRESETN button for about 3 seconds, then release the MRESETN button only.
R The main monitor starts up and enters programming mode.
3. When the display lights up, release all the buttons.
4. Press the soft keys under the
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing M
5. Enter the room number.
a. Press or
b. Press to accept the entered number and advance the cursor.
c. Press when finished.
52
, the settings will be saved in the main monitor only, and the main monitor will restart. To save
N, M N, and M
/OFF
to select the desired number.
to select the desired number.
to allow or prohibit lift usage for visitors to each lobby.
, the settings will be saved in the main monitor only, and the main monitor will restart. To save
N, M N, and M
and
to select the desired number.
or to select whether you want to overwrite the
.
N at the same time (3 buttons total).
or to select whether you want to overwrite the
.
N at the same time (3 buttons total).
soft key icons to select "Apartment mode" ®
.
N.