D-Link DES-3550 Command Line Interface Reference Manual page 69

config firmware
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure firmware section 1 as a boot up section:
DES-3550:4# config firmware section_id 1 boot_up
Command: config firmware section_id 1 boot_up
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure the firmware section as a boot up section, or to
delete the firmware section
config firmware image_id <int 1-2> [delete | boot_up]
This command is used to configure the firmware section. The user
may choose to remove the firmware section or use it as a boot up
section.
image_id – Specifies the working section. The Switch can hold two
firmware versions for the user to select from, which are specified by
image ID.
delete – Entering this parameter will delete the specified firmware
section.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section.
Only administrator-level users can issue this command.
65