Time And Sntp Commands - D-Link DES-3550 Command Line Interface Reference Manual

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
Each command is listed, in detail, in the following sections.
DES-3550 Layer 2 Fast Ethernet Switch
Parameters
{primary <ipaddr> | secondary <ipaddr> |
poll-interval <int 30-99999>}
<date ddmmmyyyy > <time hh:mm:ss >
{operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
[disable | repeating {s_week <start_week 1-4,last> |
s_day <start_day sun-sat>| s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_week <end_week 1-4,last> |
e-day <end_day sun-sat> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} |
annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> |
offset [30 | 60 | 90 | 120]}]
216
T SNTP C
IME AND
25
OMMANDS