D-Link DES-3550 Command Line Interface Reference Manual page 30

config ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, with learning and state enabled:
DES-3550:4#config ports 1-3 speed 10_full learning enable state
enable
Command: config ports 1-3 speed 10_full learning enable state
enable
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure the Switch's Ethernet port settings.
config ports[<portlist | all> {speed [auto | 10_half | 10_full |100_half |
100_full | 1000_full} | flow_control [enable | disable] | learning
[enable | disable] state [enable | disable] description <desc 32>
This command allows for the configuration of the Switch's Ethernet ports.
Only the ports listed in the <portlist> will be affected.
all − Configure all ports on the Switch.
<portlist> − Specifies a port or range of ports to be configured.
speed – Allows the user to adjust the speed for a port or range of ports.
The user has a choice of the following:
• auto − Enables auto-negotiation for the specified range of ports.
• [10 | 100 | 1000] − Configures the speed in Mbps for the
specified range of ports. Gigabit ports are statically set to 1000
and cannot be set to slower speeds.
• [half | full] − Configures the specified range of ports as either
full-duplex or half-duplex.
flow_control [enable | disable] – Enable or disable flow control for the
specified ports.
learning [enable | disable] − Enables or disables the MAC address
learning on the specified range of ports.
state [enable | disable] − Enables or disables the specified range of ports.
description <desc 32> - Enter an alphanumeric string of no more than 32
characters to describe a selected port interface.
Only administrator-level users can issue this command.
26