D-Link DES-3550 Command Line Interface Reference Manual page 71

show config
Purpose Used to display the current or saved version of the configuration settings of the
switch.
Syntax show config [ current_config | config_in_nvram ]
Use this command to display all the configuration settings that are saved to NV
Description
RAM or display the configuration settings as they are currently configured. Use the
keyboard to list settings one line at a time (Enter), one page at a time (Space) or
view all (a).
The configuration settings are listed by category in the following order:
Parameters current_config – Entering this parameter will display configurations entered without
being saved to NVRAM.
config_in_NVRAM - Entering this parameter will display configurations entered and
saved to NVRAM.
Restrictions None.
DES-3550 Layer 2 Fast Ethernet Switch
1. Basic (serial port, Telnet and
web management status)
2. storm control
3. IP group management
4. syslog
5. QoS
6. port mirroring
7. traffic segmentation
8. port
9. port lock
10. 8021x
11. SNMPv3
12. management (SNMP traps
RMON)
13. vlan
14. FDB (forwarding data base)
15. MAC address table notification
16. STP
17. SSH
18. SSL
19. ACL
20. SNTP
21. IP route
22. LACP
23. ARP
24. IP
25. IGMP snooping
26. access authentication control
(TACACS etc.)
67