D-Link DES-3550 Command Line Interface Reference Manual page 135

config 802.1p default_priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1p default priority on the Switch:
DES-3550:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to configure the 802.1p default priority settings on the Switch. If
an untagged packet is received by the Switch, the priority configured
with this command will be written to the packet's priority field.
config 802.1p default_priority [<portlist> | all] <priority 0-7>
This command allows you to specify default priority handling of
untagged packets received by the Switch. The priority value entered
with this command will be used to determine which of the four
hardware priority queues the packet is forwarded to.
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies that the command applies to all ports on the Switch.
<priority 0-7> − The priority value you want to assign to untagged
packets received by the Switch or a range of ports on the Switch.
Only administrator-level users can issue this command.
131