D-Link DES-3550 Command Line Interface Reference Manual page 190

show 802.1x auth_configuration
Purpose Used to display the current configuration of the 802.1x server on the Switch.
Syntax show 802.1x auth_configuration {ports <portlist>}
Description The show 802.1x user command is used to display the 802.1x Port-based or MAC-
based Network Access control local users currently configured on the Switch.
ports <portlist> − Specifies a port or range of ports to view.
Parameters
The following details are displayed:
802.1x Enabled / Disabled − Shows the current status of 802.1x functions on the Switch.
Authentication Mode – Shows the authentication mode, whether it be by MAC address or
by port.
Authentication Protocol: Radius_Eap − Shows the authentication protocol suite in use
between the Switch and a RADIUS server. May read Radius_Eap or Radius_Pap.
Port number − Shows the physical port number on the Switch.
Capability: Authenticator|None − Shows the capability of 802.1x functions on the port
number displayed above. There are two 802.1x capabilities that can be set on the
Switch: Authenticator and None.
AdminCtlDir: Both / In − Shows whether a controlled Port that is unauthorized will exert
control over communication in both receiving and transmitting directions, or just the
receiving direction.
OpenCtlDir: Both / In − Shows whether a controlled Port that is unauthorized will exert
control over communication in both receiving and transmitting directions, or just the
receiving direction.
Port Control: ForceAuth / ForceUnauth / Auto − Shows the administrative control over the
port's authorization status. ForceAuth forces the Authenticator of the port to become
Authorized. ForceUnauth forces the port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure and the start of a
new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant (user) to send EAP
Request / Identiy packets.
SuppTimeout − Shows the time to wait for a response from a supplicant (user) for all EAP
packets, except for the Request / Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a Radius server.
MaxReq − Shows the maximum number of times to retry sending packets to the
supplicant.
ReAuthPeriod − Shows the time interval between successive re-authentications.
ReAuthenticate: Enabled / Disabled − Shows whether or not to re-authenticate.
Restrictions Only administrator-level users can issue this command.
DES-3550 Layer 2 Fast Ethernet Switch
186