D-Link DES-3550 Command Line Interface Reference Manual page 147

Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DES-3550:4#config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DES-3550:4#
enable gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3550:4#enable gvrp
Command: enable gvrp
Success.
DES-3550:4#
DES-3550 Layer 2 Fast Ethernet Switch
Used to enable GVRP on the Switch.
enable gvrp
This command, along with disable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP
configuration on the Switch.
None.
Only administrator-level users can issue this command.
143