Table of Contents
Advertisement
10-2
screws through the hinge into the frame make sure the frame is
1
/
" above the top of the hinge to avoid the possibility of damaging the
16
glass, then tighten them down.
1/32"
1/16"
•
Loosen all the Allen head screws in the corners of the inner and outer
frames shown in the diagram.
•
Tighten the outer frame Allen head screws in the order shown in the
diagram, 2 per corner.
•
Tighten the inner frame Allen head screws in the order shown in the
diagram, 4 per corner.
1
5
8
4
•
Lift the frame and push the gas shocks back onto the ball joints.
•
Reinstall the safety clips into the ends of the gas shocks.
to
Allen
Screw
Hinge
Bar
End View
94MS41 Rev. C1 S/W Ver 2.06
Outer
Frame
3
7
6
2
1
/
" to
32
Advertisement
Table of Contents
