Table of Contents
Advertisement
[ S Pgt]
[ S EL_]
[ S Sur]
94MS41 Rev. C1 S/W Ver 2.06
Press and release the e key until [ S Pgt] appears in the Exposure window.
This places you in the split exposure option.
Press the V key to cycle the split exposure mode ON or OFF.
•
Press the 0 key twice to exit this mode.
•
Single Surface Mode
The printer may be programmed to use the top light only, the bottom
light only, or both lights. For exposing phototools or single sided
exposures, you may want to use only one light. Each of the 40 memories
is independent, to allow for any combination you wish on a particular
memory. While programming:
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
Press 1,2,3t 4 in sequence. The Vacuum window will read
[ S EL_] . This places you in the select mode.
Press the Y key once. The Memory window will read [ S u] .
•
Press and release the e key until [ S Sur] appears in the Exposure window.
This places you in the single surface mode.
Press the V key to turn the single surface option ON or OFF.
•
Press the 0 key twice to exit this mode.
•
Note: Press the U key to activate feature in operating mode so that the
Memory display reads [ A c] and the Exposure display reads [SUrF].
Press the V key to select bottom [ b ot_] , top [ t oP_] or both [ b oth] .
Now press the U key. If you have selected both lamps, the left
memory digit is complete and means upper and lower lamps are
selected. If you have top lamp only, the left memory digit displays
upper segment only and means only the upper lamp is selected.
If the left memory digit displays lower segment only it means
only the lower lamp is selected.
Board Count Display Mode
The printer will constantly display all the exposure information. With
the board count display option turned ON, the Vacuum window will
show a running total of the number of exposures that have taken place.
This can be very useful in verifying that all exposures were made for a
particular job.
Note: It is recommended to leave this feature OFF when the two value
or split features are activated. To activate the board count display
option:
Press the P key on the integrator to power up the light, the front remote
•
switches, and the exposure unit's computer system.
4-5
Advertisement
Table of Contents
