Table of Contents
Advertisement
[ E rr_]
[ 0 001]
[ 0 002]
[ 0 003]
[ 0 004]
[ 0 005]
[ 0 006]
[ 0 007]
[ 0 008]
4-12
Error Handling System
If an error occurs, the machine displays an error code to aid in
troubleshooting. The error codes defined are:
The message [ E rr_] will appear in the Vacuum window, and a number
in the Exposure window. Look up the number below for a description of
the condition.
Description
Frames did not reach intended position after the maximum amount of
time.
Solution: Determine why. Were the frames moving at all? Did they get
close? Is something obstructing their movement?
See I/O test mode for instructions on how to test motors and switches.
Not used.
Internal error. Please call your service rep.
Solution: Cycle the power switch.
Please note the circumstances under which this error occurred; was the
machine exposing? Calibrating? Idle? Were new exposure values being
entered? What was the last button pressed? How long ago?
Frames not in position at start of exposure.
Solution: Put the frames in position by cycling the power switch. If the
frames don't move, check the wiring to the frame motor and the frame
position sensing switches. If everything is OK, and this error still occurs,
call your service representative. See also the I/O test mode description.
Switch error. The machine thinks both frames are at the exposure position.
Possible causes are: Bad cable between master board and memory board,
switches have failed, bad or no connection to switches.
Communication error. Remote board is not communicating with the
master board.
Possible causes are: no power to remote board, bad or disconnected
communication cable.
Remote board has reset or temporarily lost power. After clearing the
error, normal function should continue.
At least one lamp intensity/frame/surface has not been calibrated.
Solution: Ensure the unit has been completely calibrated.
94MS41 Rev. C1 S/W Ver 2.06
Advertisement
Table of Contents
