Table of Contents
Advertisement
6.
Lamp Changing Instructions
!
94MS41 Rev. C1 S/W Ver 2.06
W The lamps and safety glass may be very hot and cause burns.
Prior to changing the lamp, ensure the lamp head is turned
off and allowed to complete its cooldown cycle.
OLEC recomends that every year you unplug your light, remove the
safety glass, and clean the glass and reflector with denatured alcohol and
a soft cloth. Lamps should be checked for excessive exposure times and
should be replaced if exposure time has become too long.
•
Support the safety glass on the lamp head and loosen the two thumbscrews
to release the glass. Carefully slide the holding brackets up or down. The
safety glass will slide from either side of the lamp head.
•
Loosen the thumbscrews for both lamp wire spade lugs.
•
Disconnect and remove the lamp by removing the spade lugs and wires
from under the thumscrews.
•
Carefully lift each end of the lamp (one end at a time) out of the holders
and remove the lamp from the lamp head.
•
Clean the reflector with a mild solvent, such as denatured alcohol, and a
clean soft cloth. Use glass cleaner to clean the safety glass. Dirty
10
Shutter
5
Lamp
6
7
4
6-1
Advertisement
Table of Contents
