Pppoe - Yealink SIP-T2 SERIES Administrator's Manual

Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS and
3.
Secondary DNS fields.
Click Confirm to accept the change.
4.
A dialog box pops up to prompt that settings will take effect after a reboot.
Click OK to reboot the phone.
5.
To configure the IP address mode via phone user interface:
Press Menu->Settings->Advanced Settings (default password: admin)
1.
->Network->WAN Port.
Press
2.
Press the Save soft key to accept the change.
3.
The IP phone reboots automatically to make settings effective after a period of time.
To configure a static IPv4 address via phone user interface:
Press Menu->Settings->Advanced Settings (default password: admin)
1.
->Network->WAN Port->IPv4->Static IPv4 Client.
Enter the desired value in the IPv4, Subnet Mask, Default Gateway and IPv4 Pri.DNS and
2.
IPv4 Sec.DNS field respectively.
Press the Save soft key to accept the change.
3.
The IP phone reboots automatically to make settings effective after a period of time.

PPPoE

PPPoE (Point-to-Point Protocol over Ethernet) is a network protocol used by Internet Service
Providers (ISPs) to provide Digital Subscriber Line (DSL) high speed Internet services. PPPoE
allows an office or building-full of users to share a common DSL connection to the Internet.
PPPoE connection is supported by the IP phone Internet port. Contact your ISP for the PPPoE
user name and password. PPPoE is not applicable to SIP-T42G, SIP-T41P and CP860 IP phones.
or to select IPv4 or IPv4 & IPv6 from the IP Mode field.
Getting Started
85