Pppoe - Yealink SIP T46G Administrator's Manual

Administrator's Guide for SIP-T46G IP Phone
The IP phone reboots automatically to make the settings effective after a period of
time.
Note
Using the wrong network parameters may result in inaccessibility of your phone and may
also have an impact on your network performance. For more information on these
parameters, contact your network administrator.
PPPoE (Point-to-Point Protocol over Ethernet) is a network protocol used by Internet
Service Providers (ISPs) to provide Digital Subscriber Line (DSL) high speed Internet
services. PPPoE allows an office or building-full of users to share a common DSL
connection to the internet. The Internet port on the IP phones can be configured as a
PPPoE port to connect to the Internet. Contact your ISP for the PPPoE username and
password.
Procedure
PPPoE can be configured using the configuration files or locally.
Configuration File
Local
To configure PPPoE via web user interface:
1. Click on Network->Basic.
2. In the IPv4 Config block, mark the PPPoE radio box.
20
<y000000000028>.cfg
Web User Interface
Phone User Interface
Configure PPPoE on the IP phone.
For more information, refer to

PPPoE

on page 235.
Configure PPPoE on the IP phone.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network&q=load
Configure PPPoE on the IP phone.