Table of Contents
Advertisement
10.3. Paint Hoses
10.3.1. Paint hose - QD version (HR)
• Step 1: Side handle, unscrew the fitting using a
15mm open-ended spanner.
• Step 2: Release the paint hose from base.
• Step 3: Using a 21 mm open-ended spanner,
unscrew the upper nut of the paint hose, then
stop loosening manually by maintaining the nut
of bottom.
• Step 4: Check that the seal of the paint nut is in
place. Check that the two olives
910018200) are installed on the paint hose (they
can be lost in the event of leakage caused by
inadequate tightening). In case olives must be
removed, replace them necessarily by news.
To reassemble, follow the steps in reverse order.
Tighten manually the upper paint hose nut until it levels the reinforcement of the
Index revision : C - March 2016
Step 1
Step 2
(P/N
31
Step 3
barrel.
7105
Advertisement
Table of Contents
