Table of Contents
Advertisement
WARNING : Before any maintenance work on the spray gun, always refer to the health and safety
instructions
- Disconnect the control module from the power supply.
- Check that the air and paint circuits are not pressurised.
- Dump the paint circuit.
10.2. Electropneumatic coupling
• Step 1: Remove paint hose. Loosen the paint
hose nut with a 15mm open-ended spanner.
• Step 2: Unscrew the fitting nut of the 7/10
polyurethane air hose with an open-ended
spanner of 16.
• Step 3: Remove the low voltage cable with a 3mm
allen key, unscrew the two captive screws from
the electropneumatic coupling.
• Step 4: Pull the electropneumatic coupling apart
to disconnect.
• Step 5: Loosen the air nipple using a 14mm open-ended spanner and replace it.
Index revision : C - March 2016
(see § 2 page
8).
Step 1
Fitting
Step 2
Step 3
Step 4
30
7105
Advertisement
Table of Contents
