Step 2: Route Audio To The Send Effect - Native Instruments MASCHINE Manual

11.3.2

Step 2: Route Audio to the Send Effect

Once you have configured a Sound or Group as send effect (see
Sound or Group as Send
that Sound or Group. For this purpose, each Sound and each Group is equipped with an addi-
tional two auxiliary outputs available in its Output properties.
Here we describe the procedure in Arrange view. You can also do this in Mix view — see
section ↑8.1.2, Configuring the Main Output of Sounds and
You can repeat the process to route more Sounds/Groups to the same send effect, or route the
same Sound/Group to an additional send effect send using
Routing Audio to the Send Effect on the Controller
1. Press the CONTROL
2. If you want to route a Group's output to the send effect, press Button 2 to select the
GROUP tab, if necessary press
containing the Group, and press the Group button
Group.
3. If you want to route a Sound's output to the send effect, press Button 3 to select the
SOUND tab, select the Group containing that Sound as described in the previous step,
and press SELECT
mode).
4. Press Button 5 (CHANNEL) to show the Channel properties of the selected Sound/Group.
Effect), you can send the output of any other Sounds and Groups to
button to enter Control mode.
SHIFT + the Group button
+ the pad of that Sound (or simply press its pad if pads are in Group
↑11.3.1, Step 1: Set Up a
Groups.
AUX 2.
A–H corresponding to the bank
A–H corresponding to the desired
MASCHINE - Manual - 611
Using Effects
Creating a Send Effect