Native Instruments MASCHINE Manual page 449

MASCHINE 1.x owners: In previous MASCHINE versions MIDI/host automation was only
possible via the Macro Controls. Now MIDI/host automation and Macro Controls are un-
related: MIDI/host automation can be configured directly on parameters, independently
of your Macro Control assignments. Macro Controls now specifically serve as shortcuts
(or "aliases") for parameters — see section
with the Macro Controls
The Automation pane holds two tabs:
▪ MIDI tab: Click the MIDI
then remote control and automate MASCHINE parameters from any MIDI-capable device or
software. Possible MIDI messages are Pitch wheel, Program Change, and MIDI CC 0–127.
▪ Host tab: Click the
SCHINE is running as a plug-in. You can then remote control and automate MASCHINE
parameters from your host application.
Under each automatable parameter of the current Parameter page, the Automation pane shows
an Assignment field showing the current assignment for this parameter, if any. If the parameter
has no assignment yet, the Assignment field reads
the parameter cannot be automated, its Assignment field is grayed out and inactive (see below
to know which parameters can be automated).
A MIDI CC assignment for the current Parameter page.
for more information.
tab to assign MIDI messages to automatable parameters. You can
Host tab to assign automation IDs to automatable parameters if MA-
Audio Routing, Remote Control, and Macro Controls
↑8.3, Creating Custom Sets of Parameters
Learn (MIDI tab) or
Using MIDI Control and Host Automation
Enable (Host tab). If
MASCHINE - Manual - 449