Additional Requirements For Abb Motors Of Types Other Than M2_, M3_, M4_, Hx_ And; Additional Requirements For Braking Applications; Additional Requirements For Abb High-Output And Ip23 Motors; Additional Requirements For Non-Abb High-Output And Ip23 Motors - ABB ACS880-37 Hardware Manual

Additional requirements for ABB motors of types other than M2_, M3_, M4_, HX_
and AM_
Use the selection criteria given for non-ABB motors.

Additional requirements for braking applications

When the motor brakes the machinery, the intermediate circuit DC voltage of the drive
increases, the effect being similar to increasing the motor supply voltage by up to
20 percent. Consider this voltage increase when specifying the motor insulation
requirements if the motor will be braking a large part of its operation time.
Example: Motor insulation requirement for a 400 V AC line voltage application must be
selected as if the drive were supplied with 480 V.

Additional requirements for ABB high-output and IP23 motors

The rated output power of high output motors is higher than what is stated for the particular
frame size in EN 50347 (2001). This table shows the requirements for ABB random-wound
motor series (for example, M3AA, M3AP and M3BP).
Nominal mains
voltage (AC line
voltage)
U < 500 V Standard
N
500 V < U < 600 V Standard
N
or
Reinforced
600 V < U < 690 V Reinforced
N

Additional requirements for non-ABB high-output and IP23 motors

The rated output power of high-output motors is higher than what is stated for the
particular frame size in EN 50347 (2001). If you plan to use a non-ABB high-output motor
or an IP23 motor, consult the motor manufacturer.
Motor insulation ABB du/dt and common mode filters, insulated N-end motor
system
P
P
-
+ du/dt
-
+ du/dt
Guidelines for planning the electrical installation 79
Requirement for
bearings
< 100 kW 100 kW < P
N
< 140 hp 140 hp < P
N
+ N
+ du/dt + N
+ N
+ du/dt + N
< 200 kW P > 200 kW
N N
< 268 hp P > 268 hp
N N
+ N + CMF
+ du/dt + N + CMF
+ N + CMF
+ du/dt + N + CMF