ABB ACS880-37 Hardware Manual page 17

Support the top and
bottom of the module
when extracting it from the
cubicle!
50 mm (2") max.
Lift the module by the upper part
only using the lifting eyes at the
top!
•
Beware of hot surfaces. Some parts, such as heatsinks of power semiconductors,
remain hot for a while after disconnection of the electrical supply.
•
Beware of hot air exiting from the air outlets.
•
Keep the drive in its package or protect it otherwise from dust and burr from drilling
and grinding until you install it. Protect also the installed drive against dust and burr.
Electrically conductive debris inside the drive can cause damage or malfunction.
•
Vacuum clean the area around the drive before the start-up to prevent the drive
cooling fan from drawing the dust inside the drive.
•
Do not cover the air inlet or outlet when the drive is running.
•
Make sure that there is sufficient cooling. See section
(page 59).
Do not tilt!
Mind your fingers! Keep fingers
away from the edges of the front
flange of the module!
Safety instructions 17
Do not leave the module
unattended on a sloping floor!
Support the top and bottom
of the module when
reinserting it into the cubicle!
Examining the installation site