Related Documents; Categorization By Frame Size And Option Code - ABB ACS880-37 Hardware Manual

24 Introduction to the manual
Electrical installation gives instructions on wiring the drive.
Control units of the drive contains the default I/O connection diagrams, descriptions of the
terminals and technical data for the control units of both the supply and inverter units.
Installation checklist contains a list for checking the mechanical and electrical installation
of the drive.
Start-up describes the start-up procedure of the drive.
Fault tracing describes the fault tracing possibilities of the drive.
Maintenance contains preventive maintenance instructions.
Technical data contains the technical specifications of the drive, eg. the ratings, sizes and
technical requirements, provisions for fulfilling the requirements for CE and other
markings.
Dimensions contains example dimension drawings of the drive.
The Safe torque off function describes the Safe torque off function of the drive and gives
instructions on its implementation.
Resistor braking describes selection, protection, wiring and start-up of optional brake
choppers and resistors. The chapter also contains technical data.

Related documents

See List of related manuals on the inside of the front cover.

Categorization by frame size and option code

Some instructions, technical data and dimension drawings which concern only certain
frame sizes are marked with the symbol of the frame size. The frame size indicates the
number of power modules that form the supply and inverter units respectively. For
example, the marking "2×R8i + 2×R8i" refers to a drive that has a supply unit consisting of
two frame R8i IGBT supply modules and an inverter unit consisting of two frame R8i
inverter modules. The frame size is marked on the type designation label (see page 54),
and can also be determined from the type code (see table under Frame sizes and power
module types, page 183).
The instructions, technical data and dimension drawings which only concern certain
optional selections are marked with option codes (such as +B054). The options included in
the drive can be identified from the option codes visible on the type designation label (see
page 54). The option selections are listed in section Type designation key (page 55).