Punch-In Recording - Yamaha Electone STAGEA ELB-02 Owner's Manual

Punch-in Recording

                                     
This lets you re-record over a specific phrase or section—either that of a specific
part(s) or all parts.
1
Connect the compatible USB flash drive to the [USB TO DEVICE]
terminal.
2
Press the [MDR] button, then select the Song which contains the
phrase you want to change.
For details on selecting a song, see steps 2 and 3 on page 135.
3
Press the [PLAY/PAUSE] button to start playback of the Song.
4
Press the [PLAY/PAUSE] button at the point you want to execute
punch-in recording.
The current Song is stopped momentarily.
5
Press the [RECORD] button.
The lamp of the [RECORD] button lights, indicating that the MDR is ready to
record.
6
Set the parts which you want to change to "RECORD" status and
other parts to "PLAY."
Part settings can be set in Pages PART 1 and PART 2. You can cancel the record
standby mode at this point by pressing the [STOP] button.
7
Press the [PLAY/PAUSE] button to start punch-in recording. Play
the new phrase, as you want it to be changed.
8
Press the [STOP] button to quit punch-in recording as soon as you
reach the end of the phrase.
NOTE
This function is best used
when the phrase to be
rerecorded has definite
beginning and end points,
with slight pauses before
and after.
Reference Page
Compatible USB flash drives
(page 127)
Reference Page
Recording Each Part
Separately (page 140)
143
ELB-02 Owner's Manual
6