Re-Recording A Specific Section-Punch In/Out (Rec Mode Page) - Yamaha DGX-670 Reference Manual

6
Use the [8 ] (Save) buttons to carry out the Save operation.
For details, refer to "Basic Operations" in the Owner's Manual.
NOTICE
The edited Song data will be lost if you select another Song or turn off the power to the instrument without carrying out the Save opera-
tion.
Re-recording a Specific Section—Punch In/Out (Rec Mode page)
When re-recording a specific section of an already-recorded Song, use the Punch In/Out function. In this
method, only the data between the Punch In point and the Punch Out point is overwritten with the newly
recorded data. Keep in mind that the notes before and after the Punch In/Out points are not recorded over,
although you will hear them play back normally to guide you in the Punch In/Out timing.
1
Select the desired Song for re-recording.
2
Call up the operation display.
[MENU] → Cursor buttons [][][E][F] Song Creator, [ENTER] → TAB [E] Rec Mode
3
Determine the settings for recording.
[1 ]–
Rec Start
[3 ]
(Punch In)
[4 ]–
Rec End
[6 ]
(Punch Out)
3
Determines the recording start behavior by using the [1 ]/[2 ] but-
tons.
• Normal: Overwrite recording starts when the Song playback is started via
the SONG [F/ K]] (Play/Pause) button or when you play the keyboard in
the Synchro Standby mode.
• First Key On: The Song plays back normally, then starts overwrite record-
ing as soon as you play the keyboard.
• Punch In At: The Song plays back normally up to the beginning of the
indicated Punch In measure, then starts overwrite recording at that point.
You can set the Punch In measure by using the [3 ] buttons.
Determines the recording end behavior, or how data is handled after record-
ing is stopped by using the [4 ]/[5 ] buttons.
• Replace All: This deletes all data after the point at which recording is
stopped.
• Punch Out: The Song position at which recording is stopped is regarded as
the Punch Out point. This setting maintains all data after the point at which
recording is stopped.
• Punch Out At: Actual overwrite recording continues until the beginning of
the specified Punch Out measure (set with the corresponding display but-
ton), at which point recording stops and normal playback continues. This
setting maintains all data after the point at which recording is stopped. You
can set the Punch Out measure by using the [6 ] buttons.
6
DGX-670 Reference Manual
4
53