Table of Contents
Advertisement
3
Formatting a USB Flash Drive
If you find that you are unable to use a new, blank USB flash drive or an old one that
has been used with other devices, you may need to format it. Formatting erases all
the data in the USB flash drive and makes it ready to record. The data erased by
formatting will be lost permanently. Check whether or not the USB flash drive
contains any important data you wish to keep before executing the operation.
Proceed with caution, especially when connecting multiple USB flash drives.
1
Connect the compatible USB flash drive to the [USB TO DEVICE]
terminals.
2
Press the [MDR] button on the panel to call up the MDR display.
3
Select the desired USB flash drive you want to format.
If a single USB flash drive is connected, only USB 01 will be displayed. After
that, if you connect another USB flash drive, the latter one will be displayed as
USB 02. If the desired USB flash drive is not selected, use the DATA
CONTROL dial to select the desired one.
4
Press the Page buttons at the top right of the display to call up the
TOOLS1 Page.
Currently
selected USB
flash drive name
Reference Page
Compatible USB flash drives
(page 127)
Reference Page
If USB flash drive cannot be
found: (page 129)
NOTE
If two (or more) USB flash
drives are connected, which
of them is labeled USB 01 or
USB 02 may change when
you turn on the power to the
instrument.
133
ELB-02 Owner's Manual
6
Advertisement
Table of Contents
