Re-Recording A Specific Section - Punch In/Out - Yamaha cvp-701 clavinova Reference Manual

Re-recording a Specific Section — Punch In/Out
When re-recording a specific section of an already-recorded Song, use the Punch IN/OUT function. In this
method, only the data between the Punch In point and the Punch Out point is overwritten with the newly
recorded data. Keep in mind that the notes before and after the Punch In/Out points are not recorded over,
although you will hear them play back normally to guide you in and out of the Punch In/Out timing.
1
Select the Song you want to re-record.
2
Call up the operation display.
[FUNCTION] → TAB [L][R] MENU2 → [B] SONG CREATOR → TAB [L][R] REC MODE
3
Determine the settings for recording.
[1] – REC START
[3] (Punch In)
[4] – REC END
[6] (Punch Out)
Determines the recording start behavior.
NORMAL
Overwrite recording starts when pressing the SONG CONTROL
[PLAY/PAUSE] button or when you play the keyboard in the Synchro
Standby mode.
FIRST KEY ON
The Song plays back normally, then starts overwrite recording as soon
as you play the keyboard.
PUNCH IN AT
The Song plays back normally up to the beginning of the indicated
Punch In measure, then starts overwrite recording at that point. You can
set the Punch In measure by pressing the [3] button.
Determines the recording stop behavior, or how data is handled after
recording is stopped.
REPLACE ALL
This deletes all data after the point at which recording is stopped.
PUNCH OUT
The Song position at which recording is stopped is regarded as the
Punch Out point. This setting maintains all data after the point at which
recording is stopped.
PUNCH OUT AT
Actual overwrite recording continues until the beginning of the speci-
fied Punch Out measure (set with the corresponding display button), at
which point recording stops and normal playback continues. This setting
maintains all data after the point at which recording is stopped. You can
set the Punch Out measure by pressing the [6] buttons.
CVP-701 Reference Manual
5
57