Connecting To An Iphone/Ipad; Wireless Lan Settings - Yamaha Electone STAGEA ELB-02 Owner's Manual

NOTE
Yamaha website address is
on page 9 in this Owner's
Manual.
NOTE
MIDI and [USB TO HOST]
terminals are automatically
disabled when the USB
wireless LAN adaptor is
connected.
Reference Page
• Wireless LAN Detailed
Settings (page 198)
• Initialize the settings in the

wireless LAN settings

(page 200)
NOTICE
When you use the
instrument along with an
application on your
iPhone/iPad, we
recommend that you first
set "Airplane Mode" to
"ON" then set "Wi-Fi" to
"ON" on your iPhone/iPad
in order to avoid noise
caused by communication.
10
NOTICE
Do not place your iPhone/
iPad in an unstable
position. Doing so may
cause the device to fall and
result in damage.
NOTE
Before using the USB [TO
DEVICE] terminal, be sure to
read "Precautions when
using the USB [TO DEVICE]
terminal" on page 132.
192
ELB-02 Owner's Manual
6

Connecting to an iPhone/iPad

You can connect a smart device such as an iPhone or iPad to the instrument. By
using an application tool on your smart device, you can take advantage of convenient
functions and get more enjoyment out of this instrument.
 For details on connections, refer to the "iPhone/iPad Connection Manual" on the
website (page 9).
 For information about compatible smart devices and application tools, access the
following page:
http://www.yamaha.com/kbdapps/
Connection with a USB wireless LAN adaptor (sold
separately):
The USB wireless LAN adaptor lets you connect the Electone to an iPhone/iPad
wirelessly. For details about the USB wireless LAN adaptor (sold separately), contact
your nearest Yamaha representative or the distributor listed at the end (or
beginning) of this manual. Or you can access the following website and contact
Yamaha support at your location.
http://www.yamaha.com/contact/
To connect the Electone to an iPhone/iPad wirelessly, follow the instructions in the
"iPhone/iPad Connection Manual" on the website, and also refer back to the
Owner's Manual (this book) for the specific Wireless LAN settings (below) which
you'll need to make for wireless connection.
Wireless LAN settings
                                     
Start wireless connection according to the instructions in the "iPhone/iPad
Connection Manual" on the website, then make sure to make appropriate setups
from the following instructions: "Display the Networks and connecting to the access
point, " "Automatic Setup by WPS, " "Manual Setup" or "Connecting by the Adhoc
Mode. " Refer to pages 192 – 196 in this Owner's Manual, then set up as required.
If there is no access point, follow the instructions in "Connecting by the Adhoc
Mode" (page 196).
Automatic Setup by WPS
1
Set the Wireless LAN mode to "INFRASTRUCTURE," if necessary.
Refer to "Wireless LAN Mode" on page 197.