Re-Recording A Specific Section-Punch In/Out - Yamaha Tyros3 Reference Manual

8
Press the [4 ▲▼] button to select the whole-note length.
9
Play the chord C in the chord section of the keyboard.
10
Press the [STOP] button (or press the [C] button) to return to the top
of the Song, then hear the newly entered Song by pressing the [PLAY/
PAUSE] button.
11
Press the [EXIT] button to exit from the Step Recording display.
12
Press the [F] (EXPAND) button to convert the input chord change data
into the Song data.
13
Press the [I] (SAVE) button to execute the Save operation.
Re-Recording a Specific Section—Punch In/Out
When re-recording a specific section of an already-recorded Song, use the Punch IN/OUT function. In this method,
only the data between the Punch In point and the Punch Out point is overwritten with the newly recorded data.
Keep in mind that the notes before and after the Punch In/Out points are not recorded over, although you will hear
them play back normally to guide you in the Punch In/Out timing.
1
Call up the operation display.
[DIGITAL RECORDING] → [A] SONG CREATOR → TAB [
2
Determine the settings for recording.
[1 ▲▼]–
REC START (Punch
[3 ▲▼]
In)
NEXT PAGE
Q Q Q Q ][ W W W W ] REC MODE
Determines the Punch In timing.
NORMAL: Overwrite recording starts when pressing the SONG [PLAY/PAUSE]
button or when you play the keyboard in the Synchro Standby mode.
FIRST KEY ON: The Song plays back normally, then starts overwrite record-
ing as soon as you play the keyboard.
PUNCH IN AT: The Song plays back normally up to the beginning of the indi-
cated Punch In measure, then starts overwrite recording at that point. You
can set the Punch In measure by pressing the [3 ▲▼] button.
CAUTION
The recorded Song data will be
lost if you select another Song or
turn the power to the instrument
off without executing the Save
operation.
Tyros3 Reference Manual • 61
3
3