Datcom - Fronius IG-TL 3.0 Operating Instructions Manual

DATCOM

Data communication control, signal activation, signal settings, signal test, DATCOM night
mode, protocol settings
Setting range
STATUS
Displays data communication available via Solar Net or an error that occurred in data com-
munication
Signal Mode
Controls the switching of the 12 V message output on the data communications rack
Unit
Setting range
Factory setting
Permanent / ALL:
ON:
OFF:
Signal Test
Function test to determine whether or not the 12 V message output turns on periodically
Night Mode
DATCOM night mode; controls DATCOM and display operation at night or when there is
not enough DC voltage available
Unit
Setting range
Factory setting
AUTO:
ON:
STATUS / Signal Mode / Signal Test / Night Mode / Protocol
Type
-
Permanent / ALL / ON / OFF
ALL
Switches the 12 V message output for continual and temporary
service codes (e.g., a brief interruption of power being fed into
the grid, a service code occurring more than 50 x per day)
The 12 V message output is turned on continually while the in-
verter is operating (as long as the display lights up or displays.)
The 12 V message output is not turned on.
-
AUTO / ON / OFF
AUTO
DATCOM operation is constant as long as a Data logger is con-
nected to an active, uninterrupted Solar Net.
The display is dark during the night and can be activated by
pressing any key.
DATCOM operation is constant as long as DATCOM compo-
nents are connected to Solar Net (even when Solar Net is inter-
rupted). The inverter provides 12 V constantly to supply Solar
Net with power.
The display is always active.
IMPORTANT When the DATCOM night mode is ON or on
AUTO with connected Solar Net components, the power con-
sumption of the inverter is increased at night to 7.3 W.
75