Choosing A Location For Inside Installation; Choosing A Location For Outdoor Installation - Fronius IG-TL 3.0 Operating Instructions Manual

Choosing a Loca-
During certain operation phases the inverter may produce a slight noise. For this reason
tion for Inside In-
it should not be installed in an occupied living area.
stallation
Do not install the inverter in:
-
-
-
-
-
-
-
-
-
Choosing a loca-
tion for outdoor Because of its IP 55 degree of protection, the inverter is not susceptible to hose water from
installation any direction and can also be operated in moist environments.
In order to keep inverter heating as low as possible, the inverter should not be exposed to
direct sunlight. Ideally, the inverter should be installed in a protected location, e.g., near the
solar modules or under an overhanging roof.
Do not install the inverter:
-
areas with large amounts of dust
areas with large amounts of conducting dust particles (e.g., iron filings)
areas with corrosive gases, acids or salts
areas where there is an increased risk of accidents, e.g., from farm animals (horses,
cattle, sheep, pigs, etc.)
stables or adjoining areas
storage areas for hay, straw, chaff, animal feed, fertilizers, etc.
storage or processing areas for fruit, vegetables or winegrowing products
areas used in the preparation of grain, green fodder or animal feeds
greenhouses
Where it can be exposed to ammonia, corrosive gasses, acids or salts (e.g., fertilizer
storage areas, vent openings for livestock stables, chemical plants, tanneries, etc.)
25