Menu Items In The Set-Up Menu; Standby; Datcom - Fronius Symo 3.0-3-S Operating Instructions Manual

Menu items in the Set-up menu

Standby

Manual activation / deactivation of Standby mode
-
-
-
-
-
-
-
Switching off Standby mode (manually switching off feeding energy into the grid):
1
2
"STANDBY" and "ENTER" appear alternately on the display.
Standby mode is now active.
The Startup LED shows steady orange.
Resuming feeding energy into the grid:
"STANDBY" and "ENTER" appear alternately on the display when in Standby mode.
1
The "Standby" menu item is displayed.
At the same time, the inverter enters the startup phase.
The operating state LED shows steady green when feeding energy into the grid has been
resumed.

DATCOM

Checking data communications, entering the inverter number, protocol settings
Setting range
Status
Indicates data communication is taking place via Fronius Solar Net or that a data commu-
nications error has occurred
Inverter number
Sets the number (= address) of the inverter in a system with several inverters
Setting range
Factory setting
IMPORTANT! If a number of inverters are linked together in a data communications sys-
tem, assign a unique address to each one.
Protocol type
Specifies the communications protocol to be used to transfer the data:
Setting range
No energy is fed into the grid.
The Startup LED will show steady orange.
In the display, STANDBY / ENTER are alternately displayed
In Standby mode, no other menu item at menu level can be accessed or adjusted.
The automatic switchover into the "NOW" display mode after 2 minutes of keyboard
inactivity does not occur.
Standby mode can only be terminated manually by pressing the "Enter" key.
Pressing "Enter" at any time will cause energy to resume feeding into the grid, as long
as there is no error (state code)
Select the "Standby" item
Press "Enter" function key
Press the "Enter" function key to resume feeding energy into the grid
Status / inverter number / protocol type
00 - 99 (00 = inverter address 100)
01
Solar Net / Interface *
31