Datcom; Usb - Fronius Primo Series Operating Instructions Manual

DATCOM

Check of a data communication, entry of the inverter number, DATCOM night mode, pro-
tocol settings
Setting range
Status
Displays data communication available via Solar Net or an error that occurred in data
communication
Inverter Number
Number setting (address) of the inverter in a setup where multiple solar inverters are
linked together
Setting range
Factory setting
IMPORTANT! Each inverter must be assigned its own address when using multiple in-
verters in a data communications system.
Protocol type
Defines the communication protocol used to transmit data:
Setting range
Factory setting
* The protocol type Interface Protocol only works without the Datamanager card. Avail-
able Datamanager cards must be removed from the inverter.

USB

Value settings when using a USB stick
Setting range
IMPORTANT! The time must be set correctly in order for the logging function to work prop-
erly.
Safely remove hardware
To remove a USB stick from the USB A socket on the data communication rack without
losing data.
The USB stick can be removed:
-
-
Software update
For updating inverter software using a USB stick.
IMPORTANT! Firmware may only be updated by Fronius Service Technicians or Fronius
Service Partners.
Procedure:
1
Status / Inverter number / Protocol type
00 – 99 (00 = 100 inverter)
01
Solar Net / Interface Protocol *
Solar Net
Safely remove hardware / software update / logging interval
when OK is displayed
when the "Data Transfer" LED is no longer flashing or illuminated
Download the "froxxxxx.upd" update file
(e.g., at http://www.fronius-usa.com; xxxxx stands for the respective version num-
ber)
27