Db1 Parameters Used For The Integral Real-Time Clock - Siemens S5-100U User Manual

The Integral Real-Time Clock

12.2.3 DB1 Parameters Used for the Integral Real-Time Clock

Table 12-2. DB1 Parameters for the Integral Real-Time Clock
Parameters
Block ID: CLP:
CF
CLK DBxDWy, MWz,EWv
DBxDWy, MYz,EWv
STW
STP
SAV
OHE
SET
hh:mn:ss
TIS
hh:mn:ss
OHS
wd = 1 to
dd = 01 to 31
mm = 01 to 12
yy = 0 to 99
hh = 00 to 23
mn = 00 to 59
ss = 00 to 59
hhhhhh = 0 to 999999 (hours)
1
f an argument such as seconds, for example, is not to be entered, enter XX. The clock continues to run
I
with the current data. The TIS parameter block does not acknowledge this argument.
2
If you enter AM or PM after the clock time, the clock runs in the 12-hour mode. If you omit this argument,
the clock runs in the 24-hour mode. You must use the same time mode in the SET and TIS parameter
blocks.
12-4
Argument
p
or AWv
or AWv
J/Y/N
J/Y/N
J/Y/N
wd dd.mm.yy
1 2
AM/PM
wd dd.mm.
1 2
AM/PM
1
hhhhhh:mn:ss
7 (weekday = Sun. - Sat.)
(day)
(month)
(year)
(hours)
(minutes)
(seconds)
Clock Parameters
Entering the correction factor ( C orrection F actor)
Location of the clock data ( CL oc K Data)
Location of the status word ( ST atus W ord)
Updating the clock during STOP ( ST o P)
Saving the clock time after the last change
from RUN to STOP or Power OFF ( SAV e)
Enabling the operating hours counter
( O perating H ours counter E nable)
Setting the clock time and date
Setting the prompt time ( TI mer S et)
Setting the operating hours counter
( O perating H ours counter S et)
p
v
x
y
z
j/J = yes
y/Y = yes
n/N = no
Meaning
= – 400 to 400
= 0 to 126
= 2 to 255
= 0 to 255
= 0 to 254
EWA 4NEB 812 6120-02
S5-100U