Mobile Attachment Of Edging To Shaped Parts With Curves - Festool CONTURO User Manual

Mobile attachment of edging to shaped parts with curves

The CONTURO can attach edging to curves with an inner radius of 50 mm and a minimum outer radius
of 25 – 30 mm. The thicker and more brittle the edging material is, the larger the radius must be. The
process for attaching edging to curves is essentially the same as attaching edging to straight workpieces.
However, there are some small differences that you should bear in mind.
1
The additional roller is a helpful accessory for narrow curves and awkward spots. It increases the bending radius of the edging
and offers an additional pressure point during attachment for better adhesion. To attach the additional roller, slide it into the
groove provided until it engages.
2
The additional roller helps during the attachment of edging
to tight outer curves by pressing down on the curved work-
piece together with the other roller.
3
It is always advisable to process narrow internal curves with
the additional roller.
TIGHT CURVES When affixing edging to tight internal or
external curves, set the feed speed to the 1st setting before
starting work or during the task by pressing the feed speed
button.
3
29