Sanding and polishing edges
If the result achieved with the scraper is not sufficient, you can always sand and polish the edge. Festool also
offers suitable system accessories here – for a finish adapted perfectly to the edging.
1
First attach the correct abrasive with a P320 grit to the hand sanding block.
2
You can eliminate cutter impact marks left behind after milling
by simply sanding the edge. Repeatedly move the hand sanding
block lightly over the edge in a steady motion to achieve this.
NOTE
Do not sand the surface of plastic-coated panels!
50
3
The appearance of plastic edging changes when processed and
often turns white. Attach a sanding cloth to the hand sanding
block and rework the edge to match the colour with the decor
again. The cloth produces a semi-matt finish on plastic edging
and the surface of the edge blends in with most decorative fin-
ishes.