Mobile Gluing Of Edges - Festool CONTURO User Manual

3.3 Mobile gluing of edges

The CONTURO is now ready to start fixing the edging to the work-
piece. The most important thing is that the workpiece is clamped
securely. You can work on the Festool multifunction table MFT/3
either with screw or lever clamps, or use the Festool VAC SYS vacuum
clamping system or a combination of both. The VAC SYS system
was used in our example because the workpiece is accessible from
all sides – ideal for fixing edging to round workpieces.
VAC SYS
Refer to the chapter "Tips and tricks" for further information on working with
the VAC SYS and MFT/3 as well as a plan of a workstation.  Page 66
MFT
26