Working With The Machine - Festool Carvex Series Original Operating Manual

Hide thumbs

Table of Contents

Available languages

C A R V E X

saw blade,

Switch on the jigsaw,



On a level surface, slide in the splinterguard



(not using your hand!)while the machine is op-

erating until it is flush with the front edge of the

saw base (speed setting 5). This beds in the

splinterguard.

 When it is worn, push the splinterguard approx.

3 mm further to the rear and continue using it.

 To guarantee reliable operation of the splinter-

guard, it must seal tightly on both sides of the

saw blade. A new splinterguard should there-

fore be fitted after every saw blade change to

guarantee splinter-free cuts.

7.4

Changing saw table

Open the change lever [1-9].



Removing the saw table downwards.



 Assembly is performed in reverse sequence to

removal. Ensure that the saw table is firmly

seated in the guide.

Instead of the saw table, the angle table WT-PS 400

or adaptation table ADT-PS 400 can be installed at

the support.

Never saw without the saw table, or one of

the other tables offered in the Festool acces-

sories program.

7.5

Dust extraction

WARNING

Dust hazard

Dust can be hazardous to health. Always work



with a dust extractor.

Always read applicable national regulations be-



fore extracting hazardous dust.

The extraction adapter [5-3] allows jigsaws to be con-

nected to a dust extractor (hose diameter 27 mm).

Insert the extraction adapter into the rear open-



ing of the saw table so that the hook [5-2] en-

gages in the [5-1] recess.

To remove the extraction adapter, press the



hook [5-2].

 Due to the low power consumption of the ma-

chine (low energy consumption), dust extractors

with an automatic switch-on function will some-

times only start up when the actual cut is made.

Set the dust extractor to continuous operation



for special applications (e.g. low stroke rate,

soft wood).

7.6

Adjusting the pendulum stroke

In order to process different materials with an opti-

mum feed movement the pendulum jigsaws have

an adjustable pendulum stroke. Select the desired

setting with the pendulum stroke switch [1-12]:

setting 0 = pendulum stroke off

setting 3 = maximum pendulum stroke

Recommended settings of the pendulum stroke

Hard and soft wood,chip board, wood

fibre board

Wood core plywood, plywood, plastics

Ceramic

Aluminium, NF metals

Steel

7.7

Stroke speed control

The number of strokes can be adjusted steplessly

with the adjusting wheel [1-5] between 1500 and

3800 rpm (PSB 420 EBQ: 1000 - 3800 rpm). This en-

ables you to optimise the cutting speed to suit the

respective material.

In position A, the automatic load detection is acti-

vated: The stroke speed is reduced in idling and is

controlled to the highest value when the blade en-

ters the workpiece.

Recommended stroke speed (position of the

adjusting wheel)

Hard and soft wood, plywood board, ply-

wood, chip board

Hardboard

Plastic

Ceramic, aluminium, non-ferrous metals

Steel