Regeneration; Basic Information About The Warewashing Machine - Meiko UPster U 400 Operating Instructions Manual

Operating Instructions UPster U 400 / U 500 / U 500S

11.4 Regeneration

CAUTION!
CAUTION!
CAUTION!
9735077
Switch off the machine.
Remove the stand-pipe, empty the tank.
Fill the salt solution container with 0.8 kg regenerating salt. A funnel can be used for this
if necessary.
By regenerating salt we mean here sodium chloride with a grain size of 0.3-1 mm.
The seal and the thread of the salt solution container must be cleaned before closing
the container. Carefully lock the salt solution container cover. The penetration of wash
water can reduce the capacity of the built-in water softening device.

Press the regeneration button.

The regeneration process starts automatically and lasts for about 13 minutes.
The machine cannot be used during this time. The door must remain closed.
The regeneration process is indicated by a yellow light. The machine can be filled again
when the light has gone out.
Even if the red light has not come on to indicate that the water softener is exhausted,
the regeneration process can be started by pressing the regeneration button for at least
3 seconds.
We recommend that you fill the machine immediately after the regeneration process in
order to dissolve and remove from the wash tank any salt particles that have been
spilled.
If the salt remains in the wash tank for a lengt hyperiod, this can result in corrosion and
even pitting corrosion in the bottom of the tank.
12

Basic information about the warewashing machine

The dish and glass-washing appliance is manufactured according to the latest state of
the art technology. Operation is safe.
Dangers can arise from this dish and glasswashingmachine, if it is not operated cor-
rectly, operated by untrained staff, or not used for its intended purpose.
Liability
We accept no responsibility for damage of the appliance and other objects caused by op-
erating faults, resp. non-observance of the operating instructions. Modifications to the ma-
chine - in particular technical modifications internally - carried out without the manufac-
turer's written authorization, or any modifications carried out by unauthorized persons, will
lead to the complete loss of any guarantee claims and will invalidate any liability for the
product.
Design and construction subject to change without prior notice
Page
21 44
of